Do You know you can grow snake plant from cutting? Yes You can grow snake plant from cutting! This approach is quite similar to the water method, except that it skips a step. Allow a day or two for the cut end of the leaf to callus, then place it in a container of lightly moist sand. After a few weeks, the plant will begin to root on its own.
Grow Snake Plant From Cutting in Water
Rooting cuttings in water is the simplest way to propagate a snake plant. This is a fantastic way to repurpose those “off” leaves that fall over and bend or shatter. It’s also an excellent method to put any extra leaves from your snake plant that you clip away when you want to change the way it looks.
Sharp knife or scissors, heavy glass, jar or vase, water, and rooting hormone are all things you’ll need (optional)
Carefully clip off the leaf you want to reproduce near the earth using a sharp knife or scissors. The better your outcomes, the sharper and cleaner the cut. You can soak your cutting in root hormone if you want. Next, submerge the bottom half of the leaf in water, covering roughly a quarter of the leaf.
Cut a leaf as close to the earth as possible. If your snake plant leaves are enormous, cut them into portions and submerge each section in water, as shown above. It’s crucial to preserve the leaf in the same position as when it was in the soil.
Because the leaves of the snake plant are highly polar, it will only produce roots if the edge of the leaf closest to the soil is submerged in water. If you turn the leaf the wrong way up, it will not grow new roots.
In the bottom of the cutting, I prefer to carve a V shape. This serves a variety of uses while also increasing the success rate of my cuttings. It increases the cut edge’s surface area exposed to the water, keeps the cut edge from pressing against the bottom of the glass or vase, and aids in identifying the bottom end of the leaf if I become confused at any point.
The success rate is improved by cutting a V shape on the lower edge of the leaf. Because snake plant leaves can be top heavy, a hefty vase or jar, such as a mason jar or even a tall flower vase, is recommended. Keep the leaf in a warm, indirect light environment. Replace the water in the glass or vase once a week, or whenever the water appears hazy.
Expect to wait a long time for roots to appear. Roots will most likely take two months or longer to emerge from your cutting. You can also notice some little growths or shoots emerging from the roots.
You can put your cutting in soil once the roots have sprouted. The cutting should be planted as deep as the water line on the leaf. Don’t be concerned about the minor shoots. When they’re ready, they’ll emerge from the ground. Although this is the simplest way, it may take the longest, especially if the plant receives little indirect light.
Grow Snake Plant From Cutting in Soil
You’ll need the following items, Scissors or a sharp knife, Pot, Succulent soil or any suitable planting mix,Hormone found in the roots (optional)
If you root cuttings directly in soil, you can acquire more cuttings from a single leaf. Begin by cutting the leaf you want to propagate near to the soil line with a clean, sharp knife. Then, with a very sharp knife, cut the leaf into small pieces, each about one inch long.
Allow the leaf pieces to dry out for a few days until they callous. As with all succulents, this will help prevent germs from the soil from getting into the leaf and causing rot.
Allow 2-3 days for the snake plant cuttings to dry before planting in soil. Make a mental note of which section of the leaf rises and which part falls. Dip the bottom end of the snake plant cutting into rooting hormone powder if desired. After that, plant the part of the plant that was close to the bottom in well-draining soil. Succulent soil, or a similar growing media, is ideal for this. In approximately a month, the plants will start to establish roots, and in another month, they will sprout new growth.