Is It Possible to Grow Snake Plants and Pothos Together in the Same Pot? Check Out this Awesome Guide! (2021)

In the same way as snake plants. As the requirements of the pothos are similar to those of the snake plant, this should not pose a problem. Because they tolerate full sun and are so good at handling low light


Snake Plant Requirements


Lighting

Snake plants require little maintenance. They still prefer indirect sunlight, however.


Watering

Since the snake plant is prone to rot easily, make sure the soil is well drained and do not overwater it, especially during winter. Before you water the snake plant, let the soil dry between waterings.


Temperatures

Snake plants prefer temperatures between 55 and 85 degrees Fahrenheit. However, the warmer remains the best option. When the temperature in your place is below 50 degrees Fahrenheit, you should consider planting them


Toxicity 

In any case, snake plants tend to be low in toxicity for humans. These are natural fungicides and insecticides that are derived from saponins.  Snake plants are toxic to pets and can cause gastronomical reactions, including vomiting and diarrhea in humans and animals. As well as dermatitis, an irritation of the skin, can be caused by the juices of the snake plant. Snake plants are toxic in all parts. Ingestion of any part of the product by pets increases the risk for severe allergic reactions. There can be swelling of the tissues in the mouth and esophagus due to this condition. It can be fatal if your pet consumes too much of them.


Problems and Pests 

The Sansevieria plant is easy to grow, but it does have a few issues like any other plant. Overwatering and cold are usually the major issues, but they can also encounter insects that can cause damage. It is possible for snake plants to be attacked by mealybugs and spider mites. Leaf shedding will occur when the sap of the leaves is sucked by these pests, and the leaves will be injured. If you want to eliminate the spider mites and mealybugs, dab the mealy bugs with alcohol, wash the leaves, and increase the humidity around the plant.


Photos Requirements


Lighting

Pothos are fine under any light condition. They can even tolerate low light, which is surprising. Ideally, a moderate amount of light is best. Outdoors, they can grow in partial shade to shade. You can display your plant if you wish. The only thing you need to be careful of is direct sunlight. In places with low light, pothos may lose their variegation. Since only green parts can make energy, the lack of light will be compensated by turning the leaves greener. When the pale ones become yellow, it can mean that too much light is reaching the plant.


Watering

 The soil must be kept moist. Nevertheless, you must avoid overwatering the plant. Water the soil only after the soil has dried out. If you want to make sure the roots remain moist, you can try only allowing the top two inches to dry. It is also important not to overwater it, as that can cause the roots to rot.


Temperatures 

Like snake plants, pothos can survive in temperatures ranging from 55 to 85 degrees Fahrenheit. The ones from tropical areas, on the other hand, prefer the high humidity and the temperatures of 70 to 90 degrees Fahrenheit.


Toxicity

Though severe cases are rare, pothos contain calcium oxalates, which can cause vomiting and irritation once ingested.


Problems and Pests

The problems associated with pothos can be fixed easily, which is one of the reasons it is perfect for beginners. Snake plant does not suffer from serious insect or disease problems. Scale and mealybugs are most commonly encountered. A cotton ball soaked in alcohol can be used to remove them. Another good idea is to use horticultural oil spray. As a preventative measure, it is always recommended to check the plant once a week.


More Related Articles for You!

https://allthingsgardener.com/21-snake-plants-you-can-grow-indoors/
https://allthingsgardener.com/choosing-good-pot-for-snake/
https://allthingsgardener.com/snake-plants-best-friend-2021/

Was this helpful?

Yes
No
Thanks for your feedback!