Snake plants are a low-maintenance houseplant. Repotting Snake Plants is required every now and then to keep them healthy and prospering. One of the way is propagating snake plant with soil. This repotting Snake Plants lesson walks you through the steps, the mix to use, and when to do it.
Propagating Snake Plant With Soil
You’ll need to have the following items, Scissors or a sharp knife, Pot, Succulent soil and any other similar potted mix, Hormone found in plants (optional)
If you root cuttings directly in soil, you can receive more cuttings from a single leaf. Start with removing the leaf you want to propagate near to the soil line with a clean, sharp knife. Then, with a very sharp knife, cut the leaf into small pieces, each about one inch long.
Allow the leaf pieces to dry out for a few days until they callous. As with all succulents, this will help prevent germs from the soil from getting into the leaf and causing rot. Allow 2-3 days for the snake plant cuttings to dry before planting in soil.
Snake plants must be placed in the same depth in the new pot where they grew previously, while the top of the root ball should sit 1 to 2 inches below the rim of the pot. If necessary, remove soil from beneath the root ball of the plant once it is set up in its newly prepared pot. When the plant has been correctly positioned in the pot, fill in the spaces around its roots with additional soil. Watering thoroughly after repotting settles the soil around the roots and ensures that the potting medium is evenly moist.
Make a mental note of which section of the leaf rises and which part falls. Dip the bottom end of the snake plant cutting into rooting hormone powder if desired.
After that, plant the part of the plant that was close to the bottom in well-draining soil. Succulent soil, or a similar growing media, is ideal for this. In approximately a month, the plants will start to establish roots, and in another month, they will sprout new growth.
Best Soil For Snake Plant
To do propagating snake plant with soil you need to check best soil for snake plant. Snake Plants prefer to be kept dry, thus the soil they’re planted in needs to be able to drain easily. You don’t want it to retain too much moisture since root rot will occur.
Because the succulent and cactus mix is chunky and fully aerated, I throw it in. As I’m planting, I also sprinkle in a few handfuls of organic compost (I use far less of both this and the worm compost when repotting houseplants than I do when repotting container plants in my garden) and a 1/2′′ layer of worm compost on top.
Plants with snakes do best in a moist soil mix that drains well, since snake plants easily rot. The best way to ensure adequate drainage is by using a soilless potting mix. In addition, use a terracotta pot that won’t trap water inside, and remove standing water immediately from the saucer.
Basic Snake Plant Care
After propagating snake plant with soil, you need to take care of them. Snake plants are one of the easiest houseplants to grow and also one of the most attractive. Snake plants have tall and rigid sword-shaped leaves with alternating stripes of green and gray with yellow edges, with the coloration of green and gray. They are ideal for many types of decor styles, including farmhouse chic and modern sleek.
There are probably other names you know snake plant by, such as mother-in-law’s tongue. It’s always sansevieria no matter what the common name is. Sansevieria laurentii usually has a crisp yellow border on its leaves at the Garden Center. Sansevieria is a tropical and sub-tropical plant found in Africa, Asia, and Europe.
The snake plant is one of those hard-to-kill, nearly indestructible house plants that can be grown in low light conditions and with infrequent watering. A snake plant will die from root rot if it receives too much water. The toughness of this plant makes it an excellent choice for both offices and homes. If treated with bright indirect light and watered properly, it can survive long periods of neglect. A great houseplant for beginners.