Why We Should Pruning Snake Plant?
Basically, if your snake plant’s leaves start to do their own thing, the pruning snake plant is a terrific way to straighten it up, restore some symmetry, and rapidly remedy a multitude of concerns. For the complete reasons, you can click here. Now, we really want to make your snake plants healthier and happy so keep reading to know more the guides!
Prepare The Equipment
Don’t worry! It’s not as much as you think. Here’s what should you do to keep things as simple as possible.
Start to the pruning snake plant, the sharp knife, pruners, or scissors are recommended. Usually, better prepare a knife and a pair of scissors or pruners for this job, as the knife allows me to cut the leaves off right at the soil line, and the scissors or pruners make it easier to prune leaves in the plant’s center.
Sterilize Your Equipment
Even if your tools appear to be clean on the outside, sterilize them with rubbing alcohol or boiling water. When pruning your houseplants, make sure your tools are sterile because it is very easy to spread disease from one plant to the next.
Choose The Perfect Place To Pruning Snake Plant
To pruning snake plant, choose a clean surface with plenty of space. Pruning can be a little messy because you will most likely disturb some of the soil and will be left with a lot of cut leaves at the end. A clean bench or kitchen counter will suffice, but if you are pruning your snake pant on a surface that could stain or be damaged, lay down a few sheets of newspaper.
Pruning Snake Plant Time!
Pruning snake plant is a simple procedure. Begin by inspecting your plant for health, shape, and size. Consider the shape and size you want your snake plant to be at the end of the process. This will assist you in determining which leaves to prune. To trim a snake plant, follow these three steps:
Reduce The Snake Plant’s Spread
Begin by pruning the leaves around the plant’s edge, assuming you want to prune to reduce the plant’s size rather than just remove damaged leaves. Cut each leaf as close to the soil line as possible with a sharp knife. Removing the leaf as close to the base as possible will improve the appearance of your snake plant. Stubby leaf stumps don’t look good in general, so it’s worth the extra effort to cut the leaves off as low as possible.
The best way to do this is to grip the top of the leaf, apply a little upward pressure, and make a single horizontal cut across the leaf with your knife parallel to the dirt. Snake plant leaves can be quite tough, so cutting through each one may require some effort. Instead of a series of jagged cuts, try to make a clean cut. A ragged leaf edge raises the possibility of disease entering the cut leaf stump.
Reduce The Height Of Your Snake Plant
Next step to pruning snake plant is, concentrate on the plant’s height once you’ve removed the outer leaves to your satisfaction. Cut off any leaves on the plant that are taller than you want the plant to be. For leaves in the plant’s interior, pruners or scissors are easier to use than a knife, but it is more difficult to cut the leaf off right at the base. Don’t worry about it because no one will see the leaf stumps in the plant’s interior, so your plant will still look lovely.
Remove The Damaged Leaves
After you’ve trimmed your snake plant to the desired size, look for any broken or malformed leaves that you’d like to prune to improve the plant’s aesthetic aspect. Make sure removing these won’t make your plant look unbalanced or sparse. It’s fine to have a houseplant that isn’t perfect, so don’t be concerned about plucking every single leaf with a minor flaw. When pruning snake plant, try not to prune it more than one-third of its size at a time.
Easy steps right? Now, take a note. Pruning snake plant is a stressful experience and pruning back too much can leave it vulnerable to disease, or it may simply struggle for months after pruning if you go too far. Let’s keep make them happy!